Logo
FULL SITE MENU

Recent content by tomboat

  1. T

    275 main pinion gear hole location on clamp ring and upper gear case housing

    Hi all, on my 275 I have installed new ujionts and the oil hole? on the main gear that attaches to the u join spline is located at the top area of the clamp ring aligned where the helmet bolt hole is- it came that way oem-never been worked on. Is this oil hole? in the right location?- it has...
  2. T

    How to coat a rusty U-JOINT Yoke Assembly and new U-Joints to prevent future rust problems?

    my u joints are rusty and the snap rings. I have remove the old ones and the u joint assembly is rusty-- 4 years since I replaced the last u joints. I would like to sand and use restore rust primer and use a 2 part epoxy coating on the u joint assembly and coat the new u joints as well. I will...
  3. T

    Gear Box Transmission Clatter in Model 275

    Installed in 2015 new u joints and PDS drive shaft bearing - 220 hours ago but now have a clatter when the engine is in neutral at 800 RPMs. I checked the PDS drive shaft- it and (U Joints are tight but little rusty). When I turn U Joint Yoke connected to main shaft gear going in the...
See more
Back
Top