Logo
FULL SITE MENU

Recent content by thefishermanhand

  1. T

    Shouldn’t my Cobra SX outdrive tilt further?

    I do not have a separate tilt/trim switch. When tilting up, it goes to the position showed in the picture and stops. At this point, the hydraulic pump clearly changes tone like it is no longer moving fluid, or said differently, like it cannot do anything more. First pic is of foot. Second is of...
  2. T

    Any special tips for putting water pump back together?

    I am about to put my water pump back together after putting a new seal in it. I have already got the impeller back where it goes. I am ready to put the gasket on and the outside plate. My questions are: 1. Do I need to put anything in between the gasket and the housing/back plate? 2. Should I...
  3. T

    1998 Volvo 3.0l sea water pump leaking out by shaft...

    The bearing seems tight and like new, so I decided to just replace the seal. The shaft seems to be smooth. The seal is visibly worn from the shaft spinning in it over time. Now I just need to find a new seal and do a pressure test to see if this solved the problem.
  4. T

    1998 Volvo 3.0l sea water pump leaking out by shaft...

    I'm starting the disassembly. I figure since I'm going to replace the seal I should replace the bearing too. Does thet sound like a good idea? All I will need is the seal, clip, and bearing, right? Can I order these parts separately? I have my bearing puller setup on the shaft. Does this look...
  5. T

    1998 Volvo 3.0l sea water pump leaking out by shaft...

    As the title say's my 3.0 Volvo's sea water pump is leaking out were the shaft goes into the housing. What do I need to do?
See more
Back
Top