Logo

Recent content by Telfish

  1. T

    Johnson 50 HP 1995 water in oil but holds pressure.

    You could but it;s a smaller thread size than the standard size bottom screw, so would need a special adapter.
  2. T

    Johnson 50 HP 1995 water in oil but holds pressure.

    Thanks for your response. I have some of the correct seal washers for the lower drain plug, the upper one looks like a standard o ring which I should also have. Will clean the threads as you recommend, then refill with fresh oil and do a run, then drain to see if I still have the issue. I really...
  3. T

    Johnson 50 HP 1995 water in oil but holds pressure.

    Seals were replace 4 years ago, I already have a complete seal kit.
  4. T

    Johnson 50 HP 1995 water in oil but holds pressure.

    Thanks for your help, that may be what happens in the end though I would rather not tear it apart if it's the drain plug seal.
  5. T

    Johnson 50 HP 1995 water in oil but holds pressure.

    So I re- pressurized the lower unit , put it in and out of forward and reverse multiple times, no change in pressure, spun the prop shaft backwards and forwards many times , no drop in pressure. So the only thing I need to test is run the motor and see if the water pump causes any drop. If not...
  6. T

    Johnson 50 HP 1995 water in oil but holds pressure.

    Thanks . I did pressurize the case and it help steady for 6 hours with no drop. Will try your suggestions.
  7. T

    Johnson 50 HP 1995 water in oil but holds pressure.

    I went to change my lower unit oil to find it milky, The oil separated into water and oil. Immediate thoughts are a damaged prop seal, water pump seal or gear change shaft. So I did a pressure test and sprayed soapy water on the prop seal and upper oil change screw, no bubbles. Left it at...
  8. T

    1995 50 horse 2 stroke revs increase with no throttle movement!

    I have a new to me 1995 2 cylinder 2 stroke. It starts and runs fine. Am using high octane no ethanol gas. When I set the throttle to produce 3000 revs with engine warm it gradually increases the revs to over 4000 revs and the boat speed increases. If I set it to 4000 then it will sometimes race...
Back
Top