Logo
FULL SITE MENU

Recent content by Stingray305

  1. S

    3.0 water leak question

    https://photos.app.goo.gl/XoCkMkWK1JoUSxrU9 What do you guys make of this? Can this be welded?
  2. S

    Restrictor plate orientation on exhaust riser for 3.0

    Is this the correct orientation shown? I thought I remember the opening in the plate being closest to the port side but it shows it towards starboard side in this drawing. Thanks. It's for a 2007 3.0 GJP J motor. (Part 16 is plate) Here's a zoom out shot:
  3. S

    3.0 water getting into starter

    Do you think I should replace this riser?
  4. S

    3.0 water getting into starter

    Hello I have a penta 3.0 and salt water keeps getting into the starter causing it to rust and sieze up. I have replaced the starter completely and it just happened after only a few short trips. I know have the starter cleaned up and working again but I need to figure out how the water is getting...
  5. S

    2007 Penta 3.0 raw water pump running very hot

    Hello I have a 2007 Stingray 185 LS with the 3.0 Penta. I recently had a problem of the motor overheating - it was runng 200 to 225 degrees. I inspected the impeller and found many of the veins were broken. I flush the water system and everything seemed fine and I replace the impeller. yes I...
See more
Back
Top