Hello jermbos. Your video was excellent and very helpful! Thank you so much.
Yes, I replaced the high pressure fuel filter. I installed a genuine Honda filter. Didn’t change the issue. I have purchased a Honda high pressure fuel pump but haven’t installed it yet. When I did the grommet repair...
Whoops forgot to hit send yesterday on previous post.
Well, took her out to the lake today and ran Seafoam thru ( 3/4 gallon gas & a can of Seafoam).
I couldn’t tell any change. Still has the same issue. A quick pulsing/ surging at higher speeds might be the best description. It goes away when...
Thanks NSDON, I plan on taking her out for a spin tomorrow (Saturday). I’ll load up a gallon of gas with sea foam for the ride. Like you said it can’t hurt and might cure it.
I took the prop off and marked it to tell if the hub is slipping. The hub looked intact though, but I guess looks can be...
Thanks jgmo, I’ll try marking the hub and prop. Yes, unfortunately I ran the motor before I realized the state of the gas. I didn’t go far because of the grommet issue, but I guess the damage may have been done. It idles pretty good and light to medium throttle runs good. Hard throttle and full...
I recently purchased a 16.5ft Lund Angler with a 2018 Honda BF50d. Initially, it had the insulator/grommet issue and bad gas. Don’t know how long sitting. Gas was brown! But didn’t smell like varnish. (Thanks to everyone who contributed to threads about the grommet issue and really helpful video...