Logo
FULL SITE MENU

Recent content by Ruslmo

  1. R

    88 mercury 80 hp From seemingly clogged tell tale to pressurized stream (more than I have normally seen)

    Hello all, I recently changed the impeller and housing etc on my 88 merc 80 l3 and it worked great normal steady stream. Also replaced thermostat and all worked well. Took it to the river after a decent rain and wouldn’t you know it it got somewhat clogged it would spit but defiantly wasn’t my...
  2. R

    1988 mercury 80hp NO FIRE

    Hello all, I recently acquired a 1988 TX 17 with a 1988 80hp mercury. I have good voltage on battery and cranks great but no fire, I have little experience with something this new and big, is the ignition system entirely electronic or is there an under the flywheel charge for spark? Any help at...
  3. R

    Oversized piston rings for 64 evinrude 9.5

    Does anyone know if this comes with the rings ? They don't ever wanna tell me because they are to busy to pull a part to confirm things like this 0379372 - Piston Only, .020 OS, No wrist pin Also the .40 overs they sell as well If not, where could I buy them ?
  4. R

    Whats the difference in the letters behind model numbers in the 60s 9.5

    what were the major differences between 9422R 9422S 9422A and any other model number differences? Evinrude motors
  5. R

    1964 evinrude 9.5 sportwin running good with cowl off put it on and it bogs. Possible exhaust leak ?

    My 64 9.5 sportwin runs great with cowl off but put it on and it starts bogging down, rough idle won't reach top rpm. Remove it while its running picks back up. I assume its an exhaust leak; however I don't see anything that is obvious. It is being tested in a 55 gallon barrel. Perhap it would...
  6. R

    1967 6 hp evinrude fisherman prop size

    I have a 3 blade 8 ¼ diameter by 8 inch pitch prop on a 1967 evinrude fisherman 6 hp. Factory is a 2 blade 8 inch diameter by 7 ¼ pitch. Is that a big enough difference to bog the engine when its turning the prop in water?
  7. R

    67 evinrude 6 hp fisherman torque specs

    can anyone inform me as to what the torque specs are for 1967 evinrude 6 hp fisherman for the head bolts the crankcase bolts/screws please
  8. R

    1967 6 hp evinrude fisherman

    hey so I took my 67 6 hp fisherman apart and wanted to double check. How many needles make up the bearing on the rod to crankshaft. Thanks for any help
See more
Back
Top