Logo
FULL SITE MENU

Recent content by rsh19904

  1. R

    1992 25 L 200 HP Offshore WiringTach Diagrams

    "Hi all, recently bought t "Hi all, recently bought the above boat/motor which runs fine but the tach was dead. Put in a new tach and when turn on ignition key the needle moves but when motor running, nothing. Have a merc. top mount type single lever shifter with the stock purple grey...
  2. R

    1986 150 HP Battery connection

    "Hello all, just purchased "Hello all, just purchased the above motor and wanted to know where the battery cables hook up to it? I know neg. to the starter but I have 3 solenoids and believe its the bottom one with the hot "jumper" wire going to the starter but when I attach the battery...
  3. R

    28HP Johnson cutting out at wot

    "Ok Joe, got one for you. I h "Ok Joe, got one for you. I have a mid-late 80's 28hp Johnson..just tuned up and runs great in the tank but when i took it out 2 wks ago it was running good and then started to sputter, bog down and then died after about 5 min of running under load, but started...
  4. R

    Yamaha 150 Main Harness

    "I just bought a main harness "I just bought a main harness for my 86 150 HP outboard with the 703 sidemount controller. The harness connection to the controller is female and the controller unit is also a female of exactly the same diameter, pins..etc?? is there an adapter for this that I'm...
  5. R

    92 30 Chevy with Yamaha IO

    "Hi All, Am considering pur "Hi All, Am considering purchasing a 92 21' Renken with this motor setup. Motor hasn't been run for a while but seems clean, oil is up on dipstick but hadn't checked the lower unit oil yet. Anyone know of any potential issues with this setup other than hard...
  6. R

    Installing a new gas tank in boat wo one originally

    Wanted to know if anyone had d Wanted to know if anyone had done this before? I have an 18 ft. manatee that had a 90 hp outboard that used the external tank. I put a 150 on it and now want to install a 17 gallon tank in the hull to help with weight distribution..don't want to just hack the...
  7. R

    1986 150 Propeller SizePitch needed

    "Hello All again, Just boug "Hello All again, Just bought 1986 Yamaha 150 counter rotating w/o prop and have been Johnson man and now need to know the correct size and pitch of a prop for this motor?? Also,wanted to know if anyone knows of good place to buy one..saw e-bay and most were...
  8. R

    78 Scarab with T350bs and TRS Drive

    "Hello All, Question. Have "Hello All, Question. Have the opportunity to buy above boat minus the drive systems and motors, basically hull. Which is in good shape and just needs tlc. Any ideas if I should upgrade to 454, 496 or 502's? Don't have major money and wanted to know what...
See more
Back
Top