Logo
FULL SITE MENU

Recent content by RICHRICH36

  1. R

    Mercruiser 3.0 engine removal, coupler replacement approx cost

    I feel that I should replace the coupler on a 3.0 sitting in a Bayliner Capri. I am mechanically inclined enough and actually have an alignment bar in addition to everything else required including trolley hoist. 15K #’s rated. I’m debating doing it myself or having a shop do it. Does anyone...
  2. R

    Is it too late when you smell rubber?

  3. R

    Is it too late when you smell rubber?

    I own a Mercruiser 3.0 since brand new (of course with the boat that it is in). Approx 10 years old. Only about 200 hours on it. I was cruising first trip from the ramp this season and something didnt seem and feel right. I suspected the gimbal bearing. I pulled the engine cover and could...
  4. R

    The last 1/2

    Hello all. I replaced my gimbal bearing and checked alignment. I had good grease marks on the alignment tool all the way around. I installed the outdrive by pushing it by hand gently. The last 1/2 of separation I couldn’t push by hand. I was able to easily draw it in with the nuts but I want to...
  5. R

    Mating surface for Gimble Bearing

    Hello all. I have a Alpha One Gen 2 sterndrive. I allowed water in to the bellows area due to spraying the engine compartment. I am going to replace gimble bearing, seals and possibly u joints. Here is where I am a little concerned, when I ran my finger around the area that the gimble bearing...
See more
Back
Top