Logo
FULL SITE MENU

Recent content by rammyii

  1. R

    Stern drive stuck

    "I attempted to install by reb "I attempted to install by rebuilt stern drive today and it is stuck. I checked the alignment prior to installation and that was perfect. We followed the manual oiled the shaft o rings greased the spline, put grease on the coupler and it stopped sliding in once we...
  2. R

    Shift Rod adjustment

    "I am just about to replace my "I am just about to replace my upper/lower gear assembly and I need to check my shift road adjustment, I know that it should be 7 13/64 from top of case to top of shift rod, from the pictures on the Hastings website it shows the lower drive on it's own. Firstly my...
  3. R

    Hour Meter

    "I have a OMC Ford 5.0 and the "I have a OMC Ford 5.0 and the hour meter is attached to the engine cover but I can't find any wires attached to it (recently purchased the boat), how can I wire in the hour meter in the engine compartment? Thanks"
  4. R

    Omc cobra 91

    "I've replaced the geacase "I've replaced the geacase assemblies and can't locate replacement nuts to secure the upper gearcase to the transom, can anybody tell me where I can get these from? Also I am getting a "beep" when the engine is running, I am showing no oil pressure or water temp. I...
See more
Back
Top