Logo

Recent content by primzy

  1. P

    Carbs from yamaha 100 to mercury 75

    OT699662 2003 ELPT 4S
  2. P

    Carbs from yamaha 100 to mercury 75

    Hi, Has anyone done it yet? I have mercury 75 elpt, 4 stroke, 2003 and i would like to have a bit more power. I was thinking to get carbs from merc 90, but if the engines are the same, why not yamaha 100? Many thanks
  3. P

    Yamaha f80 2003 4 stroke sigal only on one ignition coil wire

    Can you please upload foto of number description (what is what).
  4. P

    Yamaha f80 2003 4 stroke sigal only on one ignition coil wire

    Ok, I found infos about peak voltage and its different!? Hmm, confused again. Anyway I will try to measure it...
  5. P

    Yamaha f80 2003 4 stroke sigal only on one ignition coil wire

    I have tryed to measure output voltage on blck/wht and blck/orng wire, but with multimeter is imposibile. I think I need an ocsiliscope to se peak voltage, because its duration. Ground wire goes with this two mentioned wire? If so, its fine. Battery was fully charges so I did not consirn that...
  6. P

    Yamaha f80 2003 4 stroke sigal only on one ignition coil wire

    By signal I mean momental electricity traveling to sparkplug 😀 dont know how to call it... Yes I know it means nothing, but if it doesnt run OK out of water, probably it will not run in water as well. What gave me away 🙂 Yes, it mercury, but engine is same as in yamaha. I wrote here because I...
  7. P

    Yamaha f80 2003 4 stroke sigal only on one ignition coil wire

    I have already changed stator, cdi, 2x ignition coils with wires, spark plugs, throttle position sensor, complete fuel lines with 2 filters, pressure test fuel pump, checked compression, cleaned carbs, fresh fuel. Carbs are synchronized. This engine is killing me. It ruined 3 trips to sea and...
  8. P

    Yamaha f80 2003 4 stroke sigal only on one ignition coil wire

    Hi, I have a huge problem finding out what is wrong with my motor. When I was checking timing on engine I noticed that i get signal only on one wire on each ignition coil. Changed ignition coils and its the same. When I plug strobe light on wire cyl#1 stribe light blinks like it should. When I...
  9. P

    Mercury 75 4 stroke spark at sparkplug but no ignition (2&3) cylinder

    Is it possible that i am having this problems because of bad stator? I measured 1.4ohm insted of 0.7ohm on all wires (like manual suggest). I know 1 Ohm is almost nothing. I noticed with strobe light that I get blink when I am checking the wire to ignition coil. After ignition coil the blink is...
  10. P

    Mercury 75 4 stroke spark at sparkplug but no ignition (2&3) cylinder

    We are tallking about 5° off timing. No, gaps are fine. Actualy boat wasnt able to go above sometimes 2200, sometimes 4000rpm. So I cleaned carbs. Before cleaning I thought sparks were fine, checked it and at that time they were sparking.Problem is, that as soon I hit wave and boat shakes it...
  11. P

    Mercury 75 4 stroke spark at sparkplug but no ignition (2&3) cylinder

    Not a problem, carbs are pickig fuel very nice. Checked it visualy from intake side. Also they were cleaned and reasembled correctly.
  12. P

    Mercury 75 4 stroke spark at sparkplug but no ignition (2&3) cylinder

    So position sensor magicali started working, or wasnt bad at first. I corrected position of it, because timing was a bit out, now its like it should be. Engine runs better. Still sometimes I get spark and sometimes no. Checked it with strobe, and by pulling caps off. Now it bothers me, that #3...
  13. P

    Mercury 75 4 stroke spark at sparkplug but no ignition (2&3) cylinder

    Right now I assume thete might be a problem with throttle position sensor, because it does not make any reaponse when turning manualy. Anyone fammiliar with this? I also disconnected recitifire, no changes...
Back
Top