Logo
FULL SITE MENU

Recent content by pogie

  1. P

    Fuse Diagram for 2013 BF50?

    Hi. I have a 2013 BF50. The fuse panel contains 7 fuses. Recently, the fuse in the #7 position -- a 30a -- blew. I replaced it but I'd also like to know what it was. And yet, when I went looking in the owner's manual I was surprised to not find a fuse diagram. Didn't see it in the service manual...
  2. P

    Is there a shift interrupt switch in BF200s?

    Understood, thanks! I maintain the engine myself and do a decent job with the routine stuff, but it has not been professionally serviced in 5-6 year. So maybe it's time. In the meantime I'll keep at this particular issue...it doesn't seem to be getting any worse so with luck I'll either figure...
  3. P

    Is there a shift interrupt switch in BF200s?

    Please ignore partial post above ^^^^ --------------------------------------------- Iang6766, as you suggested, the screen on the EAC valve was badly crusted. I gave it a deep clean with carb cleaner and blown air. Following that I ran the engine for two full days of fishing, during which I...
  4. P

    Is there a shift interrupt switch in BF200s?

    Lang6766, as you suggested, the screen on the EAC valve was badly crusted. I gave it a deep clean with carb cleaner and blown air. Following that I ran the engine for two full days of fishing. No stalling and the idle was so quiet at times I had to look to verify the engine was on. I was about...
  5. P

    Is there a shift interrupt switch in BF200s?

    Thanks for the guidance. It confirms what I was starting to suspect. Next step, I'll start with the IAC (on the Honda's, "EAC") screen. Sounds like the cleaning procedure is to just spray the heck out of it with carb cleaner. It sounds less like the neutral saftety switch, which I would thin is...
  6. P

    Is there a shift interrupt switch in BF200s?

    Hi. I have a 2006 bf200 thats developed a stralling issue in the past two weeks that sounds an awful lot like a a sticking shift interrupt switch. That is, engine starts and runs fine, will idle for hours, no issues at all while in gear, but maybe one time in five will shudder and stall when...
See more
Back
Top