Logo

Recent content by phil_l

  1. P

    56 Evinrude 15 Lower pump housing

    "Joe, et. all, Working on a "Joe, et. all, Working on a 56 15...model 15016....After pulling the water pump housing and impeller and wear plate I fully expected to see a lower pump housing.....however I didnt. The manual I have show that one should be there. Do you guys know if in this...
  2. P

    56 evinrude 15 piston boss slop

    "Guys, I had a question reg "Guys, I had a question reguarding slop between the rod/wristpin and piston boss for a 56 evinrude 15...model 15016. Currently I have two torn down doing complete rebuilds on them. My question is when you hold the rod in one hand and move the piston against...
  3. P

    Couple of questions for Joe et al

    "I had two questions, one pert "I had two questions, one pertaining to a head gasket and one pertaining to the boss gasket for the high speed needle in the carb... For the head gasket, it seems most people say put it on dry....the shop which I buy my parts from said to use a small amount of...
  4. P

    Roll pin part number

    "Does anyone have the part num "Does anyone have the part number for the small roll pin that presses into the top of the driveshaft, which engages the spring seal mech. The motor is a 65 6h.p evinrude but I am sure the part was universal to a number of the smaller hp motors over a number of...
  5. P

    Roll pin on top of the driveshaftquestion

    Have a 65 Evinrude 6h.p. Whil Have a 65 Evinrude 6h.p. While pulling the impeller housing and impeller...I damaged the roll pin while pulling it.....My question is does it serve any function at all other than keeping the housing from sliding off the driveshaft? I cant see how it does but am...
  6. P

    1965 Evinrude Fisherman 6hp

    "Had a quick question. Just p "Had a quick question. Just picked up a 65 6hp recently and have a manual for it on the way. For this model year, do you still have to pull the powerhead to drop the lower unit to work on the water pump? Thanks Phil L"
Back
Top