Logo
FULL SITE MENU

Recent content by oran

  1. O

    1995 115Mercury engine knock. Wrist pin or rod bearing

    I bought this motor knowing it has a noise. I plan on rebuilding as I have good compression,and I will find out when I tear it down. My question is possible cause of this noise. It has a rattle noise at idle but not that loud. At 3/4 throttle the noise louder but when I come off plain it is the...
  2. O

    Hooking up tach on a 1995 115 Mercury

    I am changing over from Johnson to a Mercury. Its a 1995 115 and I need to change the settings on the back of the tach. It is a Teleflex outboard tach. Can anyone tell me which postion to use for this engine? How many poles is the charging system? Thanks in advance. Also typically how much...
  3. O

    Help with 150 GT. after shut down

    I apologize in advance if this post is long, but I want to try and give how story before I leave for work. I sold my 1988 Johnson 150 GT. to a guy and I installed it on his bass boat. His motor was 1992 Evinrude crossflow. Now after he runs it to the first spot and stops and fishes for about...
  4. O

    Powerhead swap,now no forward

    I swapped a 1988 Johnson Gt 150 model j150stlcca powerhead to a 1991 Evinrude 150 model ve150sleie this weekend with little problem. I did have to change the tilt and trim relay module and reroute a couple of wires from the term. block on the side of the motor to inside the relay block. Fired up...
  5. O

    1988 Johnson 150 GT Vro to Mech. fuel pump change over question

    Hello all, I am changing the VRO system over to mech. diaphragm fuel pumps on my 1988 150Gt Johnson, and have a few question. Question 1- Can I use the same vacuum line and just put a tee in to run the second fuel pump? Or do I need to use a second vacuum line from the other vacuum port? If I...
See more
Back
Top