Logo
FULL SITE MENU

Recent content by okubricko

  1. O

    4.3 MPI Not Starting - Starter solenoid click

    After some more research and checking with a Mercruiser certified mechanic on another board it turns out that the 90 Amp fuse was blown. I had looked at some pictures online and thought they failed catastrophically, but they don't look any different physically when their blown. For future...
  2. O

    4.3 MPI Not Starting - Starter solenoid click

    I see what you’re saying. I’ll check that tomorrow
  3. O

    4.3 MPI Not Starting - Starter solenoid click

    The starter relay has 12v across 85&86 when I turn the key. I would think that the main power relay and the fuel pump relay would also have power but I’m not seeing any.
  4. O

    4.3 MPI Not Starting - Starter solenoid click

    I’ll check to see if the relay is getting 12v. I was assuming it’s getting it because the contacts are closing and the relay clicks when I turn the key, but I’ll verify
  5. O

    4.3 MPI Not Starting - Starter solenoid click

    I guess it would be helpful to know where I need to check for 12v, where it's required for what components.
  6. O

    4.3 MPI Not Starting - Starter solenoid click

    The grounds are solid as far as I can tell. Tight and no corrosion. I assumed that since the relay was clicking that it was getting the required 12v to close the contacts.
  7. O

    4.3 MPI Not Starting - Starter solenoid click

    I'll check my grounds as well. I haven't done that yet.
  8. O

    4.3 MPI Not Starting - Starter solenoid click

    kghost, thanks for the info, battery was at 12.74v. I'll check it again and see and put it on the charger. Where did you pull that information from?
  9. O

    4.3 MPI Not Starting - Starter solenoid click

    Here’s what I found. On my engine I don’t have a slave solenoid, but relays for the main power, fuel pump and starter. The starter relay was clicking when I turned the key. I swapped it with both the fuel pump and main power relay and all three clicked. I plugged the main power in as well as...
  10. O

    4.3 MPI Not Starting - Starter solenoid click

    Thanks for the info, I’ll have to check it out after dinner.
  11. O

    4.3 MPI Not Starting - Starter solenoid click

    Where is the slave solenoid located on the engine?
  12. O

    4.3 MPI Not Starting - Starter solenoid click

    Hey there, this is my first post on this forum so thanks in advance for the help. I have a 2016 SeaRay with a Mercruiser 4.3 MPI engine. Yesterday I tried to start it and I am getting a single click on the starter solenoid when I turn the key. The battery(s) is good (I've tried two...
See more
Back
Top