Logo
FULL SITE MENU
o2batsea

o2batsea

Outstanding Contributor From DC Burbs/Maryland Eastern Shore
Joined
Last seen
Messages
2,512
Reaction score
0

Latest activity Postings About

    • o2batsea
      o2batsea replied to the thread 25 mercury will not turn over.
      It should. be sure battery is fully charged
    • o2batsea
      o2batsea replied to the thread Mercruiser 5.0ltr sudden loss of propulsion.
      That sounds ominous. I have the sinking feeling that your drive went out. It isn't cost effective to repair if the gears are gone. Try...
    • o2batsea
      o2batsea replied to the thread OMC Outdrive.
      Those old Stringer drives all use the same impeller: https://www.marineengine.com/newparts/part_details.php?pnum=OMC0777130 There are...
    • o2batsea
      o2batsea replied to the thread Mercruiser Aloha One.
      When the thermostat is closed the water from the seawater pump is bypassed and still goes through the manifolds/risers to the exhaust...
    • o2batsea
      o2batsea replied to the thread engine replacement.
      Since you paid for a resolution the fuel delivery issue, and they failed to repair it, you are entitled to some form of relief. Whether...
    • o2batsea
      o2batsea replied to the thread Lost Serial Number !.
      You can look up parts by horsepower here: https://www.marineengine.com/parts/mercury-outboard-parts/. I tried your description and found...
    • o2batsea
      o2batsea replied to the thread 496 MerCruiser 8.1 with Chirping sound at rear of engine.
      Unusual noises are a warning that something isn't right. Ignoring it won't make it go away. Your action at this point is to get the...
    • o2batsea
      o2batsea replied to the thread Hydrolock damage.
      As Mark says, run it till it don't. Keep changing the oil. Sooner or later you'll need to call the tow boat but who knows? There is a...
    • o2batsea
      o2batsea replied to the thread Hydrolock damage.
      Unfortunately the only way to be certain is to get the engine out, pull the head and oil pan and get that rod/piston out to be checked.
    • o2batsea
      o2batsea replied to the thread Cobra - Lower Transom Cable Won't Budge.
      Back when I had a Cobra drive, I had the same difficulties. If the cable is more than a few years old, it's time for a new one. Cobras...
    • o2batsea
      o2batsea replied to the thread Vibration accelerating and decelerating..
      In both cases you are loading the engine. Runs smooth unloaded. Could be misalignment, engine mounts, coupler, or a number of other...
    • o2batsea
      o2batsea replied to the thread Mariner 45 Slowly Loses RPM/Surging.
      Quicksilver is the Merc line of genuine parts. Try this: https://www.marineengine.com/newparts/part_details.php?pnum=MER1395-9022
    • o2batsea
      o2batsea replied to the thread Mercruiser 350 mag mpi bravo 3 IAC question.
      The idle air controller is for deceleration. Has nothing to do with starting or idling. It opens to allow bypass air into the engine as...
    • o2batsea
      o2batsea replied to the thread Mercruiser 5.0 Water Leak at Flywheel.
      There is a circuit breaker with a big red reset button. Try pushing that button and see if it'll spin
    • o2batsea
      o2batsea replied to the thread 1975 Ford351 Marine Engine.
      Yes it is possible to change to electronic ignition. You can get a Pertronix that fits your distributor. I don't know anything about...
    Show older items
  • Loading…
  • Loading…
Top