Logo
FULL SITE MENU

Recent content by NM_Trout

  1. N

    BF20D valve lash specs?

    I believe that the valve lash tolerances for a 2003 BF20D are as follows : Intake 0.17mm +/- 0.02mm Exhaust 0.23mm +/- 0.02mm Is this correct? Also... can I re-seat plugs once the crush washers have been crushed? Tnx!
  2. N

    2003 BF20D how to replace shift rod and driveshaft seal?

    Well, when I take off the water pump, and then remove the 3 bolts on the top of the "gear box" (for lack of better term) that plate which has the seals in it, the plate will lift up about 1/4" and then it comes to a hard stop. JGMO indicates that in order to access that area, I would need to...
  3. N

    2003 BF20D how to replace shift rod and driveshaft seal?

    I bought a used Honda 20hp for my daughter. Good compression, starts easy, seems to run well. Doing maintenance as it has been sitting for 5 years. While replacing the impeller, I noticed that the rubber seal around the shifter rod has cracks in it. Thought that it might not be a bad time...
See more
Back
Top