Logo
FULL SITE MENU

Recent content by mzak1970

  1. M

    OMC 50 Cobra motor%7e%7elooking for your input

    "I have a 1987 5.0 OMC. Short "I have a 1987 5.0 OMC. Short story is motor had blown head gaskets last year. I replaced and have been running boat for about 10-12 hours trying to get it running right. I went about troubleshooting a little backwards. Replacing wires, rotor, cap, points, plugs...
  2. M

    Gimbal bearing driver tool

    "Hi, I am trying to purchase a "Hi, I am trying to purchase a gimbal bearing driver. I was unable to locate any in stock on the internet. I am going to just machine one at work. Could anyone provide me with some basic measurements of this tool, or know where I can get a copy of a blueprint...
  3. M

    OMC Gimbal bearing questions

    "I had an earlier post titled "I had an earlier post titled "HELP! One thing leads to another". Please see that post for background info. I pulled the drive off today and the gimbal bearing fell out in to the bellows, I removed it a cleaned off all grease and inspected it. The bearing itself...
  4. M

    HELP One thing leads to another OMC

    "I have a 1987 5.0L GM mated t "I have a 1987 5.0L GM mated to a Cobra sterndrive. I just had the lower unit re-built. New propshaft, gears, re-sealed. Also just finished re-gasketing the top half of motor(both head gaskets were blown). Bottom half of the engine was not removed from the boat...
See more
Back
Top