Logo
M
Reaction score
0

Latest activity Postings About

    • M
      mills replied to the thread Yamaha F250 Thermostats.
      Slimbo, Sorry about my slow response but glad you replied. Thus I "assume" that this is normal and that there is not something wrong...
    • M
      Pulled my thermostats on my 2009 Yamaha F250 and one looked terrible, all clogged with scale and whatever, and the other one looked...
    • M
      Has anyone tried any of the Yamaha after market thermostats? I have a F250 and the ones on EBay are $11 vs $34 ???
    • M
      I have a 2009 F250BTXR Yamaha and need to replace the engine anodes. I found the 2 on each of the cylinder heads where the spark plugs...
    • M
      mills replied to the thread Honda BF2AM water in oil.
      I just used Google search and put in the Honda seal number and a number of sites popped up including Replacementparts.com They were the...
    • M
      mills replied to the thread Honda BF2AM water in oil.
      Attached are 2 pics showing where the water goes. It enters where I have colored white and then fills that whole compartment with...
      • IMG_2890.jpg
      • IMG_2891 (1).jpg
    • M
      mills replied to the thread Honda BF2AM water in oil.
      The water seal is the only thing that prevents pumped water from touching the crankshaft. If it fails water hits the steel crankshaft...
    • M
      mills replied to the thread Honda BF2AM water in oil.
      Well, I lucked out and found the seal on Replacementparts.com. I was able to remove the old seals easily without halving to take off...
    • M
      mills replied to the thread Honda BF2AM water in oil.
      Well, thanks again for all your input. I removed the extension case and, just like Jgmo said the only thing the water does is cool the...
    • M
      mills replied to the thread Honda BF2AM water in oil.
      Jgmo, The sealer did nothing. There is now a a large puddle of oil below the motor :( Just because they say the water seal is not...
    • M
      mills replied to the thread Honda BF2AM water in oil.
      Yes, the air is just exiting through the exhaust. Unfortunately, the water seal (part # 91203-ZV0-003) is not available, but the oil...
    • M
      mills replied to the thread Honda BF2AM water in oil.
      jgmo, Ran a little test. Not sure what it means butttttttt dropped the lower unit and hooked up a hose to the water inlet tube...
    • M
      mills replied to the thread Honda BF2AM water in oil.
      Jgmo, Thanks for your input. You gave me a lot to think about!! I might add that the water was getting into the oil when I had the...
    • M
      I have a 1997 Honda BF2AM outboard that I picked up. It runs great buttttt is getting water in the oil. I see that it has an "oil...
  • Loading…
  • Loading…
Top