Logo
FULL SITE MENU

Recent content by menicus

  1. M

    Help on BF200 - Overheating

    I removed it by making some tool and some welded fishing hook in the front , easily came out as it was worn out as well. I can do the same thing to replace but i prefer to remove the extension case if there is a possible way to remove and have an easy access and also check visually the state of...
  2. M

    Help on BF200 - Overheating

    Overheating issue solved. The problem was that the hose that connects the lower of the mainfold to the block was had corrosion all around it thus the inner came thinner , thus less water flow !. Tried and tested on water and now ok. Thanks guys for your help , you made me keep going !!!! I...
  3. M

    Help on BF200 - Overheating

    I would try this one. Any idea of the ratio of water in relation to vinegar? I was thinking of removing the lower unit feed a hose directly to the input pipe of the motor with a recerculating system in a barrel and will try for hours....
  4. M

    Help on BF200 - Overheating

    The blockage consists of the below pictures. Tried multiple times but still blocking poppets after every cleanup. I think that there is too much clogging in the system.
  5. M

    Help on BF200 - Overheating

    Tried this procedure , found both poppet valves blocked , removed blockage , worked fine for a little and same problem occured. The starboard manifold is cooler again. Noted that when both poppets were cleaned both manifolds were equally hot. When tried on sea problem occured after 5 mins of...
  6. M

    Help on BF200 - Overheating

    Hi guys , i need some help in determining what is the problem with the following: I owe a Honda BF200 , and recently experienced a continuous beep and temp symbol appeared on display. I have replaced impeller , both thermostats , cleaned both manifolds and still the same problem. Water is...
See more
Back
Top