Logo
FULL SITE MENU

Recent content by louies87grady

  1. L

    looking for help / advice omc outdrive

    update, after a month and finally having time. i realigned the motor and the outdrive went right on. now... on to other issues
  2. L

    looking for help / advice omc outdrive

    Thanks for the advise , im definitely watching a lot of videos on this and learning a lot. maby hopefully this is the issue.
  3. L

    looking for help / advice omc outdrive

    so thats interesting , never seen that bracket before but the wholes for the gimbal were still there i had the fiberglass guy purposefully leave them for alignment. im really concerned about the gimbals to be honest and what are the differences
  4. L

    looking for help / advice omc outdrive

    when the transom was re built it was done from the inside of the boat leave the exterior wall intact with the mount holes and hole for gimbal mount. i dont know how to check alignment after that. we had no issues with the bell house brackets bolting on to the transom mounts.
  5. L

    looking for help / advice omc outdrive

    the shaft was able to go in
  6. L

    looking for help / advice omc outdrive

    I had to replace the gimbal unit on my 87 4.3 grady the original one was corroded terribly, had to have the transom rebuilt a well. I purchased a gimbal unit off of ebay and by the looks it was the correct one barely any use. However last nigh after a few hours while attempting to put the lower...
See more
Back
Top