I have a 1985 Procraft 1750V with a 1999 Johnson oceanpro 150. The old motor was an 1985 Evinrude 150. Im trying to test the ignition but the problem is I cant tell which wire on the ignition is hot. Now I'm colorblind and I will get someone to help me look but initially this is what I have;
It...
1985 procraft 1750 v i forgot to unhook my negative when tightening the battery side of solenoid and caused a short. Now the trim/tilt doesnt work and the key doesnt work when turned. the trim/tilt switch is good. I was checking the ignition switch and when I open the control box there was a...
I decided to mess around with the cable. Where it was located wasnt working so I took off the clamp and turned the adjustment wheel clockwise. Then replaced and tried it. Lo and behold reverse and forward seem to be working, both lock the hub while neutral spins freely. I tell you, I learn...
I took the shifter cable off and I tried to shift it manually and voila!! it shifts into forward and locks the hub put the cable back on and adjusting as far as I can, it doesn't go into gear. But if I manually push the gear shifter it shifts into gear. Now this is a 1985 procraft 1750V with...
The hub was a problem, the splines were completely gone. Reverse locks the shaft as it should but forward does not. When I say there's a "ting" a good analogy is playing cards on the spokes of a bike but tinging. As I said I'm going to chk the cable by taking it off and trying to shift it by hand.
Went to Texoma camping this weekend and took the boat. 1985 Procraft 1750V with a 150 hp Evinrude. Now my father-in-law gave my wife and I this boat and he had it trailered/garaged and started it periodically but not on the water. SO needless to say I have replaced a LOT of worn ouut parts that...
It would sound like it was either getting too little or too much fuel. While working on it today I was just checking things on the motor and found the carburetor linkage just laying on the motor. When I reconnected it I was able to unhook the top carb to test and it still ran good. Could the...
I have a 1985 Evinrude 150 hp that I got from my father in law. Been fixing it up for about a year. This is a new problem that I found. In the picture, the 2 wires are connected like speaker wire, one is connected and one isn't. The other wire with the metal clip on the end, your guess is as...
Took the boat out today. The last time I took it out would start and idle fine, in fact can use separate throttle to rev the engine no problem, but when giving gas in gear in the water bogs down and dies. Could only move at slow speeds. I have replaced fuel lines the bulb and main fuel line...
I probably do God knows you weren't any help. Hopefully the other members actually like to help. You just like to puff up your chest and sound important. Compensating??? Get a life!!
What are the compression values ? WHY? It runs fine when not in gear ----Does spark jump a gap of 3/8" on all leads ? (NEW with no electrode) ----Are carburetors confirmed clean ? WHY? It runs fine when not in gear ---Running with VRO in service and tested ? WHY? It runs fine when not in gear...
It ran fine last season in fact ran fine 2 weeks ago. This is sudden so needed somewhere to start. Idles fine and using throttle without gears ramps up fine. I'm pretty sure it's none of the other bc it will ramp up out of gear