Logo
FULL SITE MENU

Recent content by latemodel

  1. L

    Trying to find correct part no. for 270 pinion gear needle bearing

    Ricardo, Thanks for the reply. As always, there is a bit more to the story. When I tore down the engine to rebuild it I found it was one of the blocks Ford used in the early seventies that had a negative piston height of 035. in. I cc’ed the combustion chamber and piston crown and with the...
  2. L

    Trying to find correct part no. for 270 pinion gear needle bearing

    I am rebuilding a water damaged Volvo Penta 270 outdrive, Serial 2745789C, built around 1975. It’s a dual bearing PDS and it was attached to a Waukesha assembled power pack that included a 165 HP Ford 302. We couldn’t find any numbers on the engine other than the Ford serial and casting numbers...
  3. L

    Trying to find correct part no. for 270 pinion gear needle bearing

    I am rebuilding a water damaged Volvo Penta 270 outdrive, Serial 2745789C, built around 1975. It’s a dual bearing PDS and it was attached to a Waukesha assembled power pack that included a 165 HP Ford 302. We couldn’t find any numbers on the engine other than the Ford serial and casting numbers...
See more
Back
Top