Logo
FULL SITE MENU

Recent content by larryh336

  1. L

    1982 Evenrude 15 water in cowling

    Sorry Racerone you are right about post 3 . I just looked back and I pulled the head on my other motor which is a back up motor . The one I’m having trouble with now I’ve never pulled anything off besides the carb . The amount of water I’m finding isn’t much but it’s enough to notice in the...
  2. L

    1982 Evenrude 15 water in cowling

    I never did head gasket in this motor it runs great and compression in both cylinders are 120
  3. L

    1982 Evenrude 15 water in cowling

    Thanks for the reply Kevin I guess I have my work cut out for me I’m hoping it’s just the water cover gasket and I can get that in without removing the head again . It looks like it’s starting by the latch for the cover I just can’t see it dripping
  4. L

    1982 Evenrude 15 water in cowling

    How it going I have a 1982 15hp that I just noticed water dripping out of both sides of the bottom of the cowling but I can’t seem to see where it’s coming in from tell tale hose and fitting look good . Any suggestions so I could order the parts and fix it before I tear it apart . Thanks
  5. L

    2019 mercury 40elpt won’t shift after water pump replacement

    Looking for some help I’m having a hell of a time getting the motor to shift when I put the lower back up after water pump replacement . I put the lower in forward gear and shifter in forward before sliding the lower back on and everything seems fine but the shift lever on the motor will not...
  6. L

    1985 Evenrude 15 problems

    All the parts I’ve changed have been factory parts I learned my lesson with the Amazon junk with the last engine I had
  7. L

    1985 Evenrude 15 problems

    Yeah, I probably should’ve done that. Both cylinders 110.
  8. L

    1985 Evenrude 15 problems

    I have a 1985 eventude 15hp model number E 15RCOB last week it idled and ran good until I ran it wide open and it would bog down I replaced the fuel lines and the fuel pump because they were leaking . Yesterday I put it in the water it started and idled for couple minutes went to take off and...
  9. L

    1985 evenrude loosing power and stalling at full throttle

    Yup looks like it’s dripping from one of the gaskets my local dealer has the part I checked the fuel tank and line on my brothers engine and ran fine . Thanks for the response I will change that out and hopefully that does the trick
  10. L

    1985 evenrude loosing power and stalling at full throttle

    It is a 15hp model number E 15RCOB water pump and impeller have been replaced has oem carb rebuild kit . I haven’t touched the fuel pump but I was just looking at it and when I pump the ball a little fuel is coming out from the gasket I got the motor for free so don’t mine putting a couple bucks...
  11. L

    1985 evenrude loosing power and stalling at full throttle

    I have a 1985 evenrude that will idle all day and run good at half throttle and below but once I go full throttle it will run for 20 seconds perfect then starts dieing like it’s running out of fuel pumping the ball seems to keep it going . Any ideas what it could be I’ve cleaned the carb put new...
See more
Back
Top