Logo
FULL SITE MENU

Recent content by kolincancer

  1. K

    Overheating 25hp 4 stroke

    Ive been doing some sensor testing and im getting results in kilo ohms when the manual only reads ohms. Ive had this result on the etc and mat. For reference my results Etc 20c =3.11 kohms 80c=194ohms Mat 20c=2870ohms 80c=.279ohm
  2. K

    Overheating 25hp 4 stroke

    yes it has a brand new thermostat. and the passages appear clear. i blew some vape thru it and it goes thru without any force required i also ran a large amount of desal thru it. the other thing i forgot to mention is the tell tale flows well until i start moving at which point it kind of gets...
  3. K

    Overheating 25hp 4 stroke

    So let me start by saying i got stuck out in the kelp beds and overheated this motor causing the cylinder head to break. i have since replaced the head and i have resolved that issue which was allowing water to mix into the motor oil. Now im having a issue of the outboard overheating after only...
  4. K

    Overheating issue?

    In addition to that the water out of the tell tale is hot enough that i can't keep my hand under it for more then 2 or 3 seconds. Also as i increase the rpms the telltale gets weaker
  5. K

    Overheating issue?

    So would that involve swapping the oil pressure sensor or a rebuild of where?
  6. K

    Overheating issue?

     Issue: my engine will alarm (continuous beep, i can't see the light and drops the rpms to 2800) if left in idle for too long or taken Over half throttle. I'm not sure which alarm however I'd assume it's tempature because the oil is perfectly at max (i realize that's not ideal however it's not...
See more
Back
Top