Logo
FULL SITE MENU

Recent content by kidn1980

  1. K

    Quick question about lower unit?

    Went out today and ran skinny and overheated and got stuck (im a rookie) on way back I noticed it stop peeing. Does that mean lower unit needs to be replaced. When I got home I flushed engine and still no water out pee hole. Thanks in advance
  2. K

    Cmc power lift model 7050 please help?

    This might be in wrong area of so please direct me in the right direction. So long story short the wires from my jack plate motor and relay. So bought a new relay and replaced all wires from jack motor to switch on center console. I am getting power all the way to motor wires but no movement. I...
  3. K

    Just a little trim question?

    Ok so my trim was working like intermittently, they told me to check my fluid so I did well open and refilled till came out. Then my dumbass had the cap off and hit trim up and BOOM squirting all over the place. So I went to bought some fluid and a pint squirt little gun/can. How much do I...
  4. K

    What to use on fuel line that broke?

    What could I do besides replacing the complete fuel pump. The nipple part broke off so I put son jb weld on and it held up with ears on but once in water it wore off, what kind of adhesive could I use? Thank you in advance
  5. K

    Leaking oil from prop help please

    The motor hasn't ran in yrs and I have replaced several things and finally got it running good. After letting it run to move fluids around and I turned off I noticed oil black leaking from the bottom of prop. So is there something I should be looking for. Thank you in advance. I tried uploading...
  6. K

    hello new to site please help with telltale

    hello all, I am new to outboard motors but pretty mechanically inclined. I was given a 1995 Johnson 130hp model number ( j130tledm) that has not started in yrs. this is what I have done so far : replaced thermostat ( didn't have any installed) replaced battery cables replaced solenoid...
See more
Back
Top