Hi all.....
I have a 150HP Verado. Due to excessive corrosion (most likely caused by electrolysis near my slip...that's another matter) the lower section of the tilt trim unit is leaking for the second time in 6 years. I have just bought a complete used unit for replacement in April, however...
Resurrecting this thread...I need to make a decision to replace the corroded trim motor, or not.
Does anyone know of a PLASTIC housing trim motor replacement for Verado 4 cylinder?
Will an ARCO hold up better than the Merc original. Pic of 4 season old Merc Trim Motor attached.
Hi all...thanks in advance for any suggestions.
I have a 2006 BW 205 Conquest with a 2006 150 Mercury Verado. Great setup and the Verado has been terrific. Plenty of power and reasonable to maintain.
However, the original Mercury trim motor operated ok but started to corrode badly for the 3...