Logo

Recent content by Jake615615

  1. J

    I'm getting frustrated. Hard Start.

    Back again. Bought just a cheap aftermarket starter and it worked flawlessly for a few months. I mean flawlessly as in tap the key and vroom. Now back to cranking a good 6 seconds than key off, restart and it will stumble to life. Once it clears (about 20 seconds). I can turn it off and...
  2. J

    I'm getting frustrated. Hard Start.

    You’re talking the battery isolators? As in what keeps the battery's separate from draining one another? There is a battery isolator in the boat. but i think the power lead goes right to the on / off switch for both of them. I think the wire was built together like a speaker wire but one larger...
  3. J

    Honda 225 Outboard Ignition Issues - Won't Start

    I think what was happening is the small terminal that triggers the starter to spin was drawing too much power. My guess is because of this small wire drawing too much, it than in turn did not have enough power to run the ECM or give enough power to the coils to make good spark. Again, im no...
  4. J

    Honda 225 Outboard Ignition Issues - Won't Start

    I just posted an update on my issue. It is somewhat similar https://www.marineengine.com/boat-forum/threads/im-getting-frustrated-hard-start.479438/ it is titled I'm getting frustrated. Hard Start. While trying to figure out my issues, i read somewhere on here that the main relay can cause the...
  5. J

    I'm getting frustrated. Hard Start.

    Well, I wanted to give and update. First thanks to both of you for the help / suggestions / ideas! Over the last few weeks, I have read just about every post on this forum concerning the symptoms I was seeing. There was a few out there that did not have a final answer or, were never figured...
  6. J

    I'm getting frustrated. Hard Start.

    Thanks so much for the replies! I have not turned it on and off 4 times, but have done it twice than start, no good. Huh, I have never thought of an 02 Sensor for starting, could try it. Odd, so the other day I ordered a new HP filter. It got caught up in the mail and I got impatient so...
  7. J

    I'm getting frustrated. Hard Start.

    2009 Honda BF200. This one is kicking my A$$. Just want to start with any help is very much appreciated! So…. Last season boat ran / started great all year until the last start up / trip to take the boat out of the water for the year. My port had a hard time starting – real hard. It would crank...
  8. J

    2009 Honda BF200 oil weep hole?

    Thanks again! You have been very helpful! It's been about 2 years and I am literally only going off your direction and you have been right every step so far. In Michigan Honda outboards are far and few between and really only a small amount of Honda dealers. I've been on a waiting list for...
  9. J

    2009 Honda BF200 oil weep hole?

    Thanks again for the reply. I have been trying for 2 years to get a shop to pull the power head to replace the oil pump seal (prob just replace the whole pump Assy. and cank seals.) Question, if you dont mind., what else should I replace while the power head us off? Anything else as...
  10. J

    2009 Honda BF200 oil weep hole?

    Thanks so much for the reply! I'll pull the starter when I get back to the boat. Looking at the diagram this is where the oil filter goes as well as the oil fill. There's not supposed to be oil back there?
  11. J

    2009 Honda BF200 oil weep hole?

    Hello everyone. 09 BF200 I have been fighting an oil leak for a few years. I thought it was coming from the shift shaft seal but confirmed its not. I finally was able to see it leak in front of me! Idled engine for about 2 mins, tilted engine all the way up, and after about 30 seconds, 1 -2...
Back
Top