Logo
FULL SITE MENU

Recent content by GWB36

  1. G

    1977 6HP EVINRUDE DIES AT HIGH SPEED

    CAN POWERPACK HEAT AND FAIL?
  2. G

    1977 6HP EVINRUDE DIES AT HIGH SPEED

    MOTOR NOW STARTS UP AND RUNS FINE FOR ABOUT 15 MINUTES THEN DIES OUT. PUMPING PLENTY OF WATER. NEW THERM AND IMPELLER. CAN IGNITION PARTS HEAT UP LIKE CARS IN THE 70'S AND 80'S DID? COOLS FOR A BIT AND STARTS AGAIN
  3. G

    1977 6HP EVINRUDE DIES AT HIGH SPEED

    Phone sends pics but no video. Says "waiting for network"
  4. G

    1977 6HP EVINRUDE DIES AT HIGH SPEED

  5. G

    1977 6HP EVINRUDE DIES AT HIGH SPEED

    Tried to wait but couldn't!
  6. G

    1977 6HP EVINRUDE DIES AT HIGH SPEED

    head gasket is blown right in the middle. head looks good. Great advise from you guys. Resurfacing head now. Let's see if it runs tomorrow!
  7. G

    1977 6HP EVINRUDE DIES AT HIGH SPEED

    HEAD GASKET SHOULD COME TODAY. TEAR DOWN TOMORROW. CAN'T SEE ANY DAMAGE WITH BORE SCOPE.
  8. G

    1977 6HP EVINRUDE DIES AT HIGH SPEED

    ORDERED HEAD GASKET. AFTER IT DIED AT HIGH RPM IT WILL STILL TURN OVER OK, BUT HASN'T RUN SINCE. WOULD HEAD GASKET CAUSE THAT?
  9. G

    1977 6HP EVINRUDE DIES AT HIGH SPEED

    Much appreciated! I'll try it. Torque specs for head bolts?
  10. G

    1977 6HP EVINRUDE DIES AT HIGH SPEED

    Time for a new one I guess
  11. G

    1977 6HP EVINRUDE DIES AT HIGH SPEED

    Haven't used it in about 5 years. Replaced water pump, thermostat, plugs, rebuilt fuel pump, all fuel lines, primer bulb, runs great at low to mid rpm. High rpm runs about 5 mins and shuts down. Pumping water fine. Won't restart. Low compression both cyls - 65.
  12. G

    1977 6HP EVINRUDE DIES AT HIGH SPEED

    COULD IT BE REED VALVES?
See more
Back
Top