Logo
FULL SITE MENU

Recent content by Greg7

  1. G

    2007 Honda BF 225 water leak

    I believe I found it. Looks like a hose came off. Port side of motor behind the VST. Now to figure out how to get it back on without taking off the VST....
  2. G

    2007 Honda BF 225 water leak

    Was it Belzona 1111 that you used?
  3. G

    2007 Honda BF 225 water leak

    I replaced the thermostats in the beginning of the season last year even though they looked good. I do agree with the theory on the flush port not doing the entire cooling system. Even if the thermostats were open they would close from the cold water being flushed through it.
  4. G

    2007 Honda BF 225 water leak

    Toward the end of the season I noticed water coming out of the front of the cover when the motor was trimmed all the way up and I was flushing the motor from the flush port with a garden hose. Also noticed it would leak out of the front of the motor when cruising above 20mph. Last time I flushed...
  5. G

    Motor died and now nothing happens when turning key

    I'm going to replace the cable boot but in the meantime I have everything wrapped with rubber tape to protect it.
  6. G

    Motor died and now nothing happens when turning key

    Not sure what it's exactly called but the rubber boot that all the lines come out of from the side of the boat has a tear in it. Whenever the motor turns to steer it would drag that wire back and forth on the exposed edge of the fiberglass.
  7. G

    Motor died and now nothing happens when turning key

    It ended up being the 10awg wire that feeds power to the ECU. Replaced it today And everything seems to be working normal again. Thanks to everyone for all the help and all the tips!
  8. G

    Motor died and now nothing happens when turning key

    Anyone happen to know what gauge wire those three are? There's two that are the same and then a smaller diameter one.
  9. G

    Motor died and now nothing happens when turning key

    I found it! One of these three cables must have a break in it right around where it goes into the motor. Pulled the cables upward and alarm started going off, dashboard lit up and fuel pump turned on. Let go of the cables and everything went dim again. Pulled them up and everything is back on...
  10. G

    Motor died and now nothing happens when turning key

    Installed the new ignition today. When I turn the key the batt/temp/engine lights come on and it beeps but still won't turn over. The beep is long and constant though and slowly dies out along with all the lights. If I try turning the key to start it the lights get dimmer but nothing else...
  11. G

    Motor died and now nothing happens when turning key

    Will do. Thanks for the tip
  12. G

    Motor died and now nothing happens when turning key

    Lanyard is on. Im going to unplug the wires to it to test the kill switch. From what I've read disconnecting the wires will bypass it.
  13. G

    Motor died and now nothing happens when turning key

    They charged to 12.9v Turning the key still does absolutely nothing. I was able to jump the starter and get the motor to turn over. It sounded good but it won't fire up. Could a faulty ignition switch keep the motor from starting?
  14. G

    Motor died and now nothing happens when turning key

    Batteries are going on 2 years old. Cables are connected to threaded battery posts with nut and washer. Connections were fairly clean but I did take them apart and clean them anyway. Multi meter was showing 12.2 on one battery and 12.3 on the other. I hooked a charger up to them this morning and...
  15. G

    Motor died and now nothing happens when turning key

    Ok, good to know, thanks. What made me try it was that I thought maybe I wasnt actually in neutral
See more
Back
Top