Logo
FULL SITE MENU

Recent content by Garpen61

  1. G

    2 port carb, 4,3 merc, disconnect or adjust the automatic choke?

    I have problem starting the engine when it has stand still for about one day. When I have started it once its starts very easy, just a touch with the starter and engine runs... I have heard that it has to do with the automatic choke, I also heard that the best way to solve the problem is to...
  2. G

    New Vortec 4,3 engine with carburator - regulate the pressurer on the electric fuel pump

    New Vortec engine in my Bayliner 2052 1991. I have to add an electrical fuel pump to my new motor. It works fine, sounds a bit loud i think. First start up I did as i used to do, turn the ignition on pump a couple times and turn the starter. It didn't start as quick as i believed and smoked...
  3. G

    connect the stock oilpressure meter to new 4,3 vortec engine

    I have installed a new Vortec egine in 1991 Bayliner 2052. I have a new oil pressure sensor that is connected to the fuel pump. when I try to find out how to connect the original oil pressure meter, using the striped cable, the needle jumps a bit backwards and stay there until i release the...
  4. G

    i have installed a new "repower" engine, 4,3. The oil level is much to high

    I have filled it with 4 liters, all information I have is 4,3 liters. The tube for the oil dip stick seems to flat out and don't make it possible to measure the depth in the oil pan. When I measure with 4 liter in it, it shows a lot over the full mark on the stick. When i try to suck some oil...
  5. G

    Replacing engine, do i have to change the setup on the carburator?

    My old engine is finnished, mercruiser 4,3LX from 1991. All is original, 2-port merccarb 175 hp. The new engine is totally new 4,3 with balance shaft and Vortec intake. They told me it should become 190 hp with the same carburator. In my head it would be logical that you have to open up the...
  6. G

    Breake-in new engine, 4,3 Vortec

    My old engine is finnished, mercruiser 4,3LX from 1991. All is original, 2-port merccarb 175 hp. The new engine is totally new 4,3 with balance shaft and Vortec intake. They told me it should become 190 hp with the same carburator. In my head it would be logical that you have to open up the...
See more
Back
Top