Thanks for the reply.
Does your estimate include boring the cylinders? The zero compression cylinder has basically extra metal that is almost welded to the cylinder wall. It is actually humped up instead of gouged. Wondering if it isn't actually part of the ring that let go although that seems...
Hi all. I am going to look at a '97 Nitro bass boat with a '97 Merc nitro series EFI 150. Are there any known issues with this motor I should look for? How reliable are the oil injection pumps on these?
I will be doing a compression test and also an on-water test drive.
TIA
Thanks, figured a broken ring before I ever took the head off. I have to get in there with a flashlight but haven't seen anything obvious yet. There is a little scoring on part of the cylinder wall but it is just in one spot and doesn't go up and down following the path of the piston. It still...
Well I found a problem but it seems it has been a problem for a while looking at the spark plug.
Overheat horn works as it should.
Compression is 80 - 88 on all cylinders but the lower starboard hole has zero compression. I will take off the head but does this usually mean the motor is done? I...
Thanks. I did not know the spitter didn't go through the motor. I do have a brand new water pump assembly I just ordered that I was going to replace today too. Again, thank you.
I haven't done either. I do know the spitter had a nice flow of water.
If it was compression, I wouldn't expect it to just die, then be hard to crank like a low battery (turned over very, very slowly) and then two minutes later fire right up and run great but I could be wrong.
I'll check...
Hi all, '85 GT 150. We were running close to full throttle and the motor just stopped. Tried to start it and the motor wouldn't hardly turn over. My son put the trolling motor in the water and started toward the dock. A minute later I tried to start again and the motor fired right up. We weren't...