Logo
FULL SITE MENU

Recent content by Flot

  1. F

    2008 BF150 - Check engine light is on, no unusual beeps, no saved codes

    Really appreciate all that detail. And makes sense on running at 3000 rpm if the motor doesn’t use the sensor until it’s warmed up and at speed. I don’t think I can perform a reset with this tool, I only had a few mins to try it and it’s a little less functional than I hoped (but got a decent...
  2. F

    2008 BF150 - Check engine light is on, no unusual beeps, no saved codes

    @HonDan I got a healtech scanner and threw it on quickly - I don't see anything particularly out of whack running at idle or low RPM, and no codes read - will check the above this weekend. I took a few screenshots between 800-1200 rpm (only ran it for a minute or two on the hose) and I did see...
  3. F

    2008 BF150 - Check engine light is on, no unusual beeps, no saved codes

    Perfect, thanks for that list, will check. I believe motor has ~250 hours on it based on previous info but have not plugged it in. I can run on muffs below ~1500 rpm no problem, higher than that and it'll throw an overheat alarm pretty quickly. I did all the routine service last year when I...
  4. F

    2008 BF150 - Check engine light is on, no unusual beeps, no saved codes

    I should have said above, I was able to simulate a different check engine code. Same light. :) I do have the 4 light console (which I bought separately from the motor) and initially I had some doubts about whether it was wired properly - but yes, the light literally says 'check' and when I...
  5. F

    2008 BF150 - Check engine light is on, no unusual beeps, no saved codes

    Update: I was able to simulate a different check engine light by unplugging the O2 sensor. This code clearly flashed when doing diagnostics, and I was able to reset THAT false code using the lanyard procedure. However, the check engine light continued to stay on for my original problem.
  6. F

    2008 BF150 - Check engine light is on, no unusual beeps, no saved codes

    Troubleshooting a new to me BF150 Engine is running great on the hose, but the check engine light is on. No unusual beeps. I performed the code read procedure by jumping the red plug -no flashes - but it gives me a confirmation beep when I reset (5 pushes on the safety lanyard trigger) which...
See more
Back
Top