Logo
FULL SITE MENU

Recent content by Eyeyiyi

  1. E

    Bf50 tilt/trim

    Well that gives me something else to consider if no pressure in tank and it is leaking there ty for the heads up on that . I’ll check the parts diagram to see location of seal to see if I should attempt it . Ty
  2. E

    Bf50 tilt/trim

    First place I checked no dice ty
  3. E

    Bf50 tilt/trim

    2007 bf50a tile trim oil tank is cracked. The part is no longer available does anyone have this problem and solution. Can I epoxy it or is there to much pressure. If I have to get a whole new unit will a newer one work on it?
  4. E

    Motor revs higher, speed down

    18’ pontoon Bf50a Honda after pulling it out and rebuilding carbs and doing fluid changes and new water pump I just got her back in the water motor ran great revs to 5500 at 16 mph. I bought the boat used and it used to go faster . The prop is originally and beat up so I got another alum prop...
  5. E

    Morton revs higher, speed down

    18’ pontoon Bf50a Honda after pulling it out and rebuilding carbs and doing fluid changes and new water pump I just got her back in the water motor ran great revs to 5500 at 16 mph. I bought the boat used and it used to go faster . The prop is originally and beat up so I got another alum prop...
  6. E

    Broke my carb need tech help

    Sorry should of included it I have a 16102-ZW4-F02 the middle carb I was wondering if any other middle carb can be used by just switching jets from different models or using 16102-ZW4-F03 bottom carb I see I can change the butterfly but not sure if I can change the fuel inlet
  7. E

    Broke my carb need tech help

    This I broke a carb getting the float pin out arg. The carbs I have is discontinued # be31cc vd17 is the hats stamped on it. They do have be31ce carbs in stock I’m hoping someone with knowledge can tell me if I can use this one.i bought all new parts for my original carbs float kits, gasket sets...
  8. E

    Bf50a carb parts I’d help

    Ty for the help I just needed to look in the right place. This is second time cleaning them 1st time did real good got up to 5500 rpm, this time hard starting poor throttle response and only gets to 4700 rpm.I haven’t removed the mixture screws and will do so now after reading how to. needle...
  9. E

    Bf50a carb parts I’d help

    Ty but still confused let’s start with the needle jet#21 it gives me 2 choices referencing engine s#.it says use bg31c d or bg31c e. My number on the frame is bazs 3703750 but the parts that references other numbers. Ok I think I got it went back and looked closer at what you sent one of the...
  10. E

    Bf50a carb parts I’d help

  11. E

    Bf50a carb parts I’d help

    Second time I’ve rebuilt these cabs in 5 yrs all my fault. What I’m trying to find out is the right parts to get. I have a 2007 Bf50a LRTA I need new needle jets and new idle screws and an exhaust gasket that specifies ordering parts to certain carb #’s. Is this right as I would like to get...
See more
Back
Top