Logo
FULL SITE MENU

Recent content by Elliotto7!

  1. E

    2006 Honda 225 timing belt help

    I agree, I RARELY use muffs, only to do quick inspections. I should get a trash can for it though, would be much easier to assess everything. I can cross a most of those off the list, spark plugs are all good and tight, ignition coil boots are all great condition, low pressure fuel pump makes a...
  2. E

    2006 Honda 225 timing belt help

    I didn’t measure the gap prior to adjusting, I adjusted them to .30mm and I couldn’t get that slid in there even a little bit so I’d imagine it was .28mm or less which is the absolute minimum you can go. I have a mechanic stethoscope and I’m still having a hard time pinpointing it. It does...
  3. E

    2006 Honda 225 timing belt help

    Did the adjustment, exhaust side of bank 1, 2, and 3 was very tight, couldn’t fit my feeler gauge in them. Did all necessary adjustments, check all of them 3 times after adjustment, started her up and faint tapping is still there. Ultimately I might be reading too into the tapping noise but my...
  4. E

    2006 Honda 225 timing belt help

    I’ve noticed these threads aren’t the easiest to navigate. Apparently they don’t like to use keywords lol.. I’ll check them all out, if there’s no wicked obvious need for adjustment I’ll likely leave them how they are
  5. E

    2006 Honda 225 timing belt help

    Thank you for the info! Never attacked it but I’m confident in doing it as I like to consider myself mechanically inclined. I’ll adjust to the middle clearance to make sure it’s not too tight and not too loose.
  6. E

    2006 Honda 225 timing belt help

    I replaced all tensioner and idler pulleys as well as the tensioner springs, pretty much any contact point that with the exception of the crank and camshaft gears. On another note, do you know if I have to drain the oil to adjust the valves?
  7. E

    2006 Honda 225 timing belt help

    I appreciate the reply, plan on attacking the valve adjustment tomorrow morning to see if there’s any strong tell take for the tapping. Hoping that’ll be the issue
  8. E

    2006 Honda 225 timing belt help

    Anyone??
  9. E

    2006 Honda 225 timing belt help

    Hi, recently did the timing belt and tensioners on one of my 225’s (doing other when parts arrive) but since I’ve replaced everything I have a light tap noise coming from the top of the motor. 1.) is the tapping noise due to needing a valve adjustment? 2.) why would it just start tapping...
See more
Back
Top