Logo
FULL SITE MENU

Recent content by dwhite0829

  1. D

    89 Mariner sluggish at first then takes off...<--Repeat for a while then acts fine.

    First I have to get to the carbs Idle Mixture screws. I stole this picture from another post I found, but it's the same engine. Last night I was going to actually do this, but when I went to take that front plate off the engine to get to the front of the cabs I ran into trouble. When I...
  2. D

    89 Mariner sluggish at first then takes off...<--Repeat for a while then acts fine.

    I have an 89 Mariner 115 hp. when I first drop in the water and start it, it runs really rough. During Idle it will spit and sputter and die. Once I get on it, it will take off slow up to about 3500 rpms. Stay there for a while then just take off like a bat... At that point it might go back...
  3. D

    Not wanting to shiftinto gear after lower unit fluid change

    I just bought an 89 procraft with a 115 Mariner. It ran great on the test drive. Put it through quite a bit to test it. Ran great. I got it home, changed the lower unit fluid since I didn't know when the last time it was changed was, thought it would be a good idea. Took it to the lake a couple...
  4. D

    1980-82 85HP power trim question

    i have a 1980-82 85 hp evenrude that runs great but has weak power trim. I thoguht maybe it was low on hydraulic fluid, but don't know where to add the fluid. Anybody know about these? If this does not work I'm assuming I'll need to replace the trim motor, but can't find anywhere to get a...
See more
Back
Top