Logo
FULL SITE MENU

Recent content by Dvdfst3

  1. D

    P175TLRV 62H Yamaha Outboard

    I have not checked the alarm but did check that the pump was not running at sensor position C. If the ground is OK could this be a problem with the CDI Assembly?
  2. D

    P175TLRV 62H Yamaha Outboard

    I will check. Thanks
  3. D

    P175TLRV 62H Yamaha Outboard

    Maybe someone can help with this issue. I do not find much information in the shop manual. My system is designed to automatically transfer oil from the remote tank to the engine tank when the level is low. I can lift the Engine Tank Level sensor out of the engine tank which should activate an...
  4. D

    Need help wiring 1997 Yam 90 to tilt/trim gauge

    Thank you for your help. I will see if I can find the correct trim gauge
  5. D

    Need help wiring 1997 Yam 90 to tilt/trim gauge

    I just bought the boat so am trying to diagnose the systems that do not work properly.
  6. D

    Need help wiring 1997 Yam 90 to tilt/trim gauge

    The cam appears to be OK. I pulled the sender and the gauge will not start to register until the sender is rotated about 3/4 of the way and full rotation shows full down. My additional question is how are there 3 wires off of the sender and only 1 sender post on the gauge. Has something been...
  7. D

    Need help wiring 1997 Yam 90 to tilt/trim gauge

    P175TLRV
  8. D

    Need help wiring 1997 Yam 90 to tilt/trim gauge

    1997 Skeeter with Yamaha 175 and faria gauge with ground, ignition and sender posts.
  9. D

    Need help wiring 1997 Yam 90 to tilt/trim gauge

    On a similar note, same setup but my gauge only works on the lower portion of trim (3 or 4 inches of travel) and not the full trim.
See more
Back
Top