UPDATE
Have connected positive cable directly from battery to starter ( I should have started here).
In any case, the starter remains unresponsive. I even tried a few hammer taps while connected.
After disconnecting power the starter turns easily by hand.
While starter has not engaged...
Once again I am confused.
I hooked up a 12 volt battery for testing. Positive to solenoid and negative to block.
I used a patch cable to jump over the solenoid - positive in to positive out. The wire got hot! I used a circuit tester to verify the outbound power cable from the solenoid was...
Thanks, I’m making some progress….
I’ve got a few photos to hopefully clarify things but too large for this site. Scroll to the bottom of this page:
https://dougmcq000.wixsite.com/mitey-mo/post/iv-outboard
Internal wiring appears complete: 2 battery cables; 2 starter wires; 2 choke wires...
Tim,
thanks for the info.
I believe the internal wiring harness is complete:
two battery cables, pair for starter, pair for choke
solenoid is under the cover.
what is purpose of junction box?
Doug
Picked this up as a “barn find”
From what I could tell from
Model number, it’s a 1956 30HP.
Appreciate if somebody could confirm
It’s a six volt system. I read somewhere
That 12 volt started in 1957
Also, my understanding is that some of the 6 volt outboards had a positive ground. How can I...
Hello,
I just picked up an antiquewooden boat to restore.
It was upgraded with a Mercruiser SN# 0L679271.
(mated to a velvet drive - please don't kick me off this forum ;-)
Has not run for five years. Step by step instructions to get this running without damaging anything would be greatly...