Logo
FULL SITE MENU

Recent content by dhicks

  1. D

    I could use some help on a Honda BF150, MIL blink code = 41; A/F Sensor Related Issue

    The service manual I have is a PDF and the page(s) that goes through the steps for testing this are blank. Regardless, using the information you provided I tested the relay. Assuming I did everything correctly, the relay is bad. No clicking in the relay, no continuity across terminals 1 & 2...
  2. D

    I could use some help on a Honda BF150, MIL blink code = 41; A/F Sensor Related Issue

    jgmo -- I was looking at the service manual and it says there should be 2-3 ohms between the two black wires on the sensor itself. I checked the original sensor and it was an open circuit (definitely bad). When I checked the new sensor it read just 1.1 ohms. Does that raise reg flag or should I...
  3. D

    I could use some help on a Honda BF150, MIL blink code = 41; A/F Sensor Related Issue

    2008 Honda BF150MIL blink code = 41 From the shop manual, that means one of these is the problem: - Open or short circuit in the A/F sensor heater wire - Faulty A/F sensor heater - Faulty ECM I don't have the HDS tester or the test harness. I've reset the malfunction indicator three times...
  4. D

    Wanted - BF135/BF150

    I'm looking for a block and/or a cylinder head for a Honda 2007 or later BF135 or BF150 4-stroke outboard motor. Must come with guarantee of usability.
See more
Back
Top