Logo
FULL SITE MENU

Recent content by danford1

  1. D

    2004 Johnson 60 hp 4 stroke intake removal

    I have a 2004 60 hp Johnson 4 stroke model J60PL4S0. I'm doing maintenance and want to clean out and inspect the high pressure fuel pump reservoir and water separator unit. I have the BRP 2005 60,70 hp manual. It sorta shows step by step procedures to remove the intake. I started following them...
  2. D

    Adding water pressure gauge to 60 hp 4 stroke

    I have a 2004/5 Johnson 60 hp 4 stroke. I bought a water pressure gauge and have it mounted. I ran the pitot tube back to the outboard, I can't figure out where to mount it. I have the BRP 2005 60 hp shop manual, but can't find ANYTHING in it about where a water pressure gauge would be hooked...
  3. D

    Adjusting timing 2004 60hp 4 stroke Johnson EFI

    I have a new to me 2004 60hp Johnson EFI on a pontoon boat. It seems to run well but I like to adjust everything as perfect as I can. I have a 2005 BRP factory shop manual. The manual is clearly intended for dealers. It doesn't give much DIY info. It says timing is 10 degrees advanced at 3000...
  4. D

    What is the black plug for? Right side of 60hp Johnson 4 stroke.

    What is the black plug for on the starboard side of a 60hp Johnson 4 stroke, mid way down.? Danford1
  5. D

    1965 75 hp V4 Evinrude need more power

    "I have a friend and he wants "I have a friend and he wants more power from his 1965 75hp V4 Evinrude. He has three 10 X 10 1/2 props. He is thinking of having one re-pitched to 10 and the other re-pitched to 9 1/2. He wants a variety for speed and pulling power for skiing. It is on an old 1972...
  6. D

    15 hp Evinrude 1980 Tiller handle gears needed

    I have a 1980 15hp Evinrude. M I have a 1980 15hp Evinrude. My tiller handle gears slip when advancing the throttle. Probably need both new gears. Where is a good place on line to get them? I don't live close to any dealers... Danford1
See more
Back
Top