Logo

Recent content by crholliday

  1. C

    4jh80 wont start

    Update: Pulled the relay and tested it as good. Tested voltage at the relay harness and the hot leg of the relay circuit is only showing 0.8v with the engine ON and when connected to the battery negative. The relay energizer legs show the correct voltage for On and Start which is consistent...
  2. C

    4jh80 wont start

    2018 4jh80 wont start. We have ultraflex throttle controls at the helm which show no errors. Powers up but when the start button is pressed, all I get is the tiniest of clicks coming from somewhere in the motor (probably some kind of solenoid). I checked the lead that goes to the start solenoid...
  3. C

    BF20d overheating

    A quick update on this: after my initial cleaning and de-salting, the engine ran fine for a couple of runs but eventually, I got the overheating buzzer and light again. As I am still waiting for a new tstat, water pump and flush adapter, I crafted a flush adapter from stuff I have on the boat...
  4. C

    BF20d overheating

    I removed the water jacket cover and cleaned all the salt and flushed as much as possible. Drilled out the broken bolt and found a replacement onboard. Put everything back together and she is running without overheating. As soon as the new tstat, and other parts arrive, I will replace.
  5. C

    BF20d overheating

    Thank you so much for the detailed response! I pulled the thermostat and tested. It starts opening around 150 degrees and is fully open at around 165. Does that seem normal? Unfortunately, I sheared off one of the two bolts while removing the thermostat cover so I will have to deal with that but...
  6. C

    BF20d overheating

    I have a 2018-ish BF20d with power tilt and remote that is throwing an overheating buzzer and red light on the throttle controls after I throttle up for a few minutes. The alarm has not come on at lower speeds for 20+ minutes. If the alarm sounds, it drops the RPMs down. If I shut off the engine...
Back
Top