Logo
FULL SITE MENU

Recent content by CrabbyTug

  1. C

    Honda BF90D

    Hello everyone, just flushed for about 20-30 minutes multiple times. Seems cleaned out, but we took it apart a little more, water pump is in pristine condition, checked all O-rings and gaskets. We noticed that we have exhaust coming up through the water bypass along with the pipe above the water...
  2. C

    Honda BF90D

    Got a flushing bag with some Redlyme, flushed it at 1800 RPM's for around 20-30 minutes. Ended up overheating which I think was because of the constantly recirculated water. Going to keep flushing it over the next few days and give it a test really soon, will keep everyone updated. Thank you...
  3. C

    Honda BF90D

    The exhaust was coming from where the thermostat covers are, we had the thermostat and the cover both removed, started it and had exhuast gasses coming from them.
  4. C

    Honda BF90D

    It was definitely exhaust gas coming out of the passages, when we ran it with them off.
  5. C

    Honda BF90D

    No they were on, with the thermostats out.
  6. C

    Honda BF90D

    We flushed it for a long time, but why would there be exhaust gas in the cooling passages? We may try and flush it again, should we use redlyme?
  7. C

    Honda BF90D

    They were full of salt before we flushed the block with acid.
  8. C

    Honda BF90D

    Salt water outboard, the thermostats were clean and we also tested them to make sure they were working properly.
  9. C

    Honda BF90D

    Hello, Currently I have a newer Honda BF90D with only 60 running hours. We have ran into the issue of it going into limp mode after 5-10 minutes of running due to an overheating issue. We through a code reader on it to confirm that it was an overheating issue. With that being said, we have...
See more
Back
Top