Logo
FULL SITE MENU

Recent content by Bsmg777

  1. B

    Please help

    I went back to the electronic ignition and the engine runs like a champ. Thanks to all for your assistance. Ron
  2. B

    Please help

    I’m unable to secure a new resistor, and tired of messing with it. I am going to order up the electronic ignition. The coil is for that, so hopefully two wires and I’ll be good. I will let you know. I’m waiting on a callback from Pentronics to make sure I can get the 2842. They said up to 10 days.
  3. B

    Please help

    Hmmm. You might be on to something. I do know the wire from coil to condenser is direct. I will check it when I get back. Give me a few days. Thank you, thank you
  4. B

    Please help

    Ok, I don’t know of this. Please elaborate
  5. B

    Please help

    The gas seems ok. I really appreciate the help, by the way. So, only one wire to the condenser, right? Coming off the negative side of coil? Points plug into same mounting clip as condenser? That’s how I have it. I took out points again and had to clean with Emory board. Reset to .016. Runs...
  6. B

    Please help

    I did, and connected it to negative side of coil.? (and did mean .030 on the plug gap). Maybe check to see if float is stuck or gummed up in carb?
  7. B

    Please help

    OMG Electronic ignition blew apart on my aq120b. Shop talked me into putting in points. I have not been able to get engine to run correctly since. Set points to .016 New plugs to .30 New fuel/water separator Made sure fuel flowing after boat sat for 1 year Added fuel and...
See more
Back
Top