Logo
FULL SITE MENU

Recent content by branch92

  1. B

    Sea pump

  2. B

    Sea pump

    I need help! My raw water pump has taken a crap it is a Sherwood G9901 and these babies are expensive! I’m curious if if the VP pump 3858847 is a direct interchange with my Sherwood pump. Picture of Sherwood pump first and then the pump I want to use is second.... i do not know what engine i...
  3. B

    96' 5.7l getting hot..

    Ok so I have a getting hot issue.... no clue why .... this is a fresh water boat.. boat has never seen salt water in its life.. 96’ VP 5.7l (throttle body injected model) with a VP DP-C1 out drive In the last month I have done -bellows -PDS bearing -rebuilt trim cylinders -oil change -new...
  4. B

    Dp-c1 trim / tilt cylinders

    Hello im looking for the thread size of the trim /tilt cylinders ports. I have one port that is gummed up and would like to clean it out with a thread chaser or tap
  5. B

    DP-C1 trim cylinder removal

    Got the rest of the drive removed ! The pivot pins came out with ease I was able to put a bolt through them and a nut on the back side and yank them out with a small slide hammer. Now I can access the trim cylinders to rebuild them. Any tips for rebuilding them in place ?
  6. B

    DP-C1 trim cylinder removal

    well now that I have gotten past my first battle of extracting the PDS shaft im on to the next one..... currently I have the gearbox off the top of the out drive and that is as far as I am tore down.. im looking for some procedures to be able to pull the trim cylinders off of the boat.. I...
  7. B

    In response to a PM from member Blake Brancheau

See more
Back
Top