Logo
FULL SITE MENU

Recent content by ballew

  1. B

    1998 115 johnson

    hello what would cause the timing light to fire on #1 cylinder and the TDC mark is opposite side of flywheel ive check sparkplug stop tool on cylinder one that the top dead ctr, is correct i was able to get the wot ( joe r. method to 4' less than factory specs) timing on the flywheel...
  2. B

    i know i should have , but didn't , any advise/help is greatly appreciated

    hello i have been fighting with ignition problems since i discovered water in cylinder # 4, long story short found a restrictor plate burned in half while replacing the plate i went threw and performed repairs as they came up ,rebuilt carbs , went threw fuel system , went threw ignition...
  3. B

    Fiber washers

    what are fiber washers used for also do i need a fiber washer when replacing ignition coil Johnson 115 outboard
  4. B

    ballew

    Re: 1998 johnson 115TSLECMalso he 4 wires from power pack Orange / blue stripe ,,,,,orange/ green should be connected to cylinders 1 top and 3 bottom right side of motor me standing behind motor, and on left side top cylinder 2 orange/ purple and bottom left cylinder 4 orange/ pink is this...
  5. B

    ballew

    Re: 1998 johnson 115TSLECMhello quick question when wiring charge coil the 2 leads either white and black or yellow and yellow/brown going to power pack is there a possibility of reversal of the 2 and if so will it cause misfiring and / or 3 cylinders firing but not all four, I'm unable to find...
  6. B

    1998 johnson 115TSLECM

    I need assistance with timing linkage my question is what's the factory lengths and possible adjustment to idle screws
See more
Back
Top