Logo
FULL SITE MENU

Recent content by AK Cheeser

  1. A

    Honda 2004 BF 150 dead to me

    Yep, right above the starter. That's the one. More checking. Thanks again.
  2. A

    Honda 2004 BF 150 dead to me

    I'll do some checking to see where that 14 pin connector plugs in. I'm pretty sure my problem is upstream a little ways. On each side of the main 90A fuse I've got 12.7V, but the feed from that post immediately to the right of the 90A fuse and then to the fuses is where I drop to .4V. No...
  3. A

    Honda 2004 BF 150 dead to me

    Thanks for the reply. I've been referencing a Honda troubleshooting guide that was sent to me. Yes, I believe it's the ECM where the 14 pin connector is located... forgive me on being a little slow with these abbreviations. That #3 connector is the white wire with the black stripe. The guide...
  4. A

    Honda 2004 BF 150 dead to me

    I performed a main line check on my 14 pin connector... measured the #3 terminal voltage and came up with only .20 volts max. I'm assuming that I need to have 12 volts here. The troubleshooting guide says that I need to repair an open (circuit?) in the main harness. No idea where to go from...
See more
Back
Top