Logo
FULL SITE MENU

Recent content by AeroCraft

  1. A

    1971 60 hp misfiring at greater than 1/2 throttle after warmed up

    My mistake clipper circuit is gone
  2. A

    1971 60 hp misfiring at greater than 1/2 throttle after warmed up

    No clipper circuit still in.
  3. A

    1971 60 hp misfiring at greater than 1/2 throttle after warmed up

    Michigan
  4. A

    1971 60 hp misfiring at greater than 1/2 throttle after warmed up

    Do you have carb kit number from Amazon having hard time finding correct one with all parts. Thanks
  5. A

    1971 60 hp misfiring at greater than 1/2 throttle after warmed up

    Did not purchase kits but fully disassembled and cleaned all orfices . If carbs were problem then why misfiring only after a few laps around lake and motor is well warmed up. Note temp of motor within range from manual using temperature gun. Low speed needle #30 removed and hole cleaned. Main...
  6. A

    1971 60 hp misfiring at greater than 1/2 throttle after warmed up

    Last checked it was 12.5 volts gone through cap and rotor again and found no carbon streaks but showing wear. New parts very hard to find and expensive
  7. A

    1971 60 hp misfiring at greater than 1/2 throttle after warmed up

    Running L77JC4 gapped at .030 as per other forums
  8. A

    1971 60 hp misfiring at greater than 1/2 throttle after warmed up

    My 1971 60 hp evininrude misfires after warming up when going past half throttle. Work completed: Carbs disassembled and cleaned Fuel pump replaced Cdi and coil unit replaced plugs replaced carbs synced and timing set to spec points gapped to .010” any help will be greatly appreciated motor...
See more
Back
Top