I tested the relays with multimeter and those seem to be fine. There was one yellow cable burnt but don't know where the other end was supposed to be because it had been burnt through the connector so it was loose. I think it might be connected to the alternator or to the black wire coming from...
I have removed orange wire from the relay also but nothing happens. Only one control panel. The orange wire goes in the key switch and leaves as orange to diode which is wired to another diodes.
I removed orange wire first from diode in key switch. Nothing changes. Then taped over the connection of orange wire under the key switch cables and still the glow light stays on same brightness.
I found the diodes being fine on the instrument panel and fuses are also fine. Cannot find any place where the wiring is broken or current could be floating to the glow light. Any ideas?
I have an old MD22 motor and the glow lights stay on always when the battery is connected even if key is not switched on. Any ideas what this can cause and how to solve it? Where are the glow plugs located? Does anyone have image of the placement or explode chart that shows it?
I have an old MD22 motor and the glow lights stay on always when the battery is connected even if key is not switched on. Any ideas what this can cause and how to solve it? Where are the glow plugs located? Does anyone have image of the placement or explode chart that shows it?
I posted this...