SeaStar Steering (Splashwell Mount Cylinder)
||< Previous Page|Next Page >|
A Very Economical Hydraulic Steering
Alternative, SeaStar splashwell mount steering
is ideal for engines which do not have
threaded engine tilt tubes (cannot use front or
side mount cylinders). The splashwell mount
cylinder typically attaches to an anchor point
on or near the inside of the boat’s transom.
An ideal hydraulic steering solution for engines
without tilt tubes.
Single and dual non-power-assisted outboard engines
up to 300 HP (600 combined HP for counter-rotating
Suitable for speeds up to 60 MPH and dual station
use (with purchase of extra helm, hose & ﬁttings).
Dual engines require purchase of a tie bar kit and
extra hardware. Not suitable for engines ﬁtted with
factory power steering.
Ideal for outboard engines which do not have a
Design allows wide variety of mountings.
Light duty alternative to front mount cylinder
where space allows.
Suitable for installation in shallow splashwells.
5.5/6.5 turns lock-to-lock using SeaStar 1.7 helm
Compact helm has only a 4-7/16” footprint —
needs only 3” dash hole (Tilt requires larger hole).
Standard 3/4” tapered steering shaft.
HC5380-3 features a compact 9” stroke for tight
Meets A.B.Y.C. standards.
Meets N.M.M.A. certiﬁcation requirements.
System components sold separately. See application
and ordering guides to select appropriate components.
SeaStar 1.7 Helm
Splashwell Mount Outboard Cylinder
Hose Kit (2 hoses)
SeaStar Oil (1 Quart)
SeaStar 1.7 - Front Mt. Commercial Helm
SeaStar 1.7 - Rear Mount Helm
SeaStar 1.7 - Sport Tilt Helm
SeaStar 1.7 - Classic Tilt Helm
Power Assist, 15' Harness
SeaStar Round Bezel Kit
SeaStar Backplate Kit
SeaStar 20° Dash Wedge Kit
SeaStar Bulkhead Hose Kit (2 hoses)
SeaStar Twin Engine Tie Bar Kit
Add-A-Station/Autopilot Fitting Kit
Cylinder seal kit
Cylinder tee/bleeder hose ﬁtting
STEERING - Outboard (Hydraulic)
SEASTAR POWER ASSIST
**Stainless steel shaft / robust shaft seal area
See Page 148