Quicksilver Marine Parts Catalog
- Contents
- Pre-1988 Mariner
- Mercury & Mariner
- Carburetor Kits
- Fuel Pump Repair Kits
- Ignition Keys
- Ignition Parts (2-Stroke)
- Ignition Parts (4-Stroke)
- Lower Unit Gearcase Seal
- Pistons
- Oil Filters
- Powerhead Gasket Sets
- Rod Main Bearings
- Solenoid Relay (2-Stroke)
- Solenoid Relay (4-Stroke)
- Spark Plugs (2-Stroke)
- Spark Plugs (4-Stroke)
- Stators
- Thermostat Kits
- Water Pump Parts (2-Stroke)
- Water Pump Parts (4-Stroke)
- Mercruiser
- Engine Parts
- View All »
- Alternators
- Camshafts, Bearings, Lifters & Push Rods
- Carburetors
- Connecting Rod Bearings
- Crankshaft Bearings
- Distributor Assembly & Components
- Distributor Gears
- ECMs, Coils, Wires & Spark Plugs
- Engine Couplers
- Engine Gaskets
- Exhaust Manifolds & Elbows
- Flame Arrestors
- Fuel Coolers
- Fuel Injection Components
- Fuel Pumps & Filters
- Ignition Tune-up Kits
- Intake & Exhaust Valves
- Oil Coolers
- Oil Pumps & Components
- Piston Rings
- Pistons
- Rocker Arms & Hardware
- Starter Parts
- Starters & Solenoids
- Thermostats, Housings & Covers
- Timing Chains & Gears
- Valve Caps, Springs & Keepers
- V-Belts & Serpentine Belts
- Water Hoses—Engine Supply
- Water Hoses—Exhaust Cooling
- View All »
- Transom & Drive Parts
- View All »
- Bearing Carriers
- Bellows
- Drive Shaft Housing & Sterndrive Units
- Drive Shaft Housing Bearings
- Drive Shaft Housing Gears
- Gear Case Bearings
- Gear Case Gears
- Gear Case Seals
- Gear Case Shafts
- Gear Case Shims
- Gimbal Bearings
- Installation Gaskets
- Trim Cylinders
- Trim Cylinder Hardware
- Trim Cylinder Hoses
- Universal Joints (U-Joints)
- Water Pump Impellers & Kits
- View All »
- Engine Parts
- Page Numbers
ELECTRICAL
BATTERY COVER - RED/POSITIVE
BATTERY CABLE KIT
Pair of 12 ft.(3.7 m) cables, 1 red (+) Positive and 1 black ( ‑) Negative, 4 gauge
Positive(Red) Snap on cover used with Battery Bus Bar kits
with ring terminals.
Any 12 volt battery that uses the new Bus Bar Kit
Fits Mercury/Mariner 75‑V6 outboards and the new Verado.
BATTERY COVER - BLACK/NEGATIVE
BATTERY BAR - MULTIPLE CONNECTOR
BATTERY MULTIPLE CONDUCTOR KIT (WITH COVERS)
Negative (Black) Snap on cover used with Battery Bus Bar kits
Any 12 volt battery that uses the new Bus Bar Kit
BATTERY PLATE - 3/8 INCH (WITH FASTENERS)
New Battery Bus Bar Kit allows multiple connection points that result in clean and
direct connections for various electrical power needs. This will eliminate stacking
of ring terminals and reduce corrosion and loose connections resulting in poor or
faulty electrical connections.
Kit includes a 3/8 inch and a 5/16 inch mounting plate made of brass with all the
fasteners needed for multiple connections. This kit also includes a positive (red)
and negative (black) cover that snaps to the plate and provides protection to the
battery connections. (ABYC compliant)
Any 12 volt battery that has a 3/8 inch and 5/16 inch pmounting stud
BATTERY MULTIPLE CONDUCTOR KIT (NO COVERS)
Multiple Conductor Battery Plate 3/8 inch (with fasteners) Clean up your battery
solutions with direct isolated connections
BATTERY PLATE - 5/16 INCH (WITH FASTENERS)
Multiple Conductor Battery Plate with fasteners (No Covers)
Clean up your battery solutions with direct isolated connections
New Battery Bus Bar Kit allows multiple connection points that result in clean and
direct connections for various electrical power needs. This will eliminate stacking
of ring terminals and reduce corrosion and loose connections resulting in poor or
faulty electrical connections.
Kit includes a 3/8 inch and a 5/16 inch mounting plate made of brass with all the
fasteners needed for multiple connections. This kit does not include plastic snap
on covers (ABYC compliant)
Any 12 Volt battery with 3/8 inch and 5/16 inch studs
264