Quicksilver Marine Parts Catalog
- Contents
- Pre-1988 Mariner
- Mercury & Mariner
- Carburetor Kits
- Fuel Pump Repair Kits
- Ignition Keys
- Ignition Parts (2-Stroke)
- Ignition Parts (4-Stroke)
- Lower Unit Gearcase Seal
- Pistons
- Oil Filters
- Powerhead Gasket Sets
- Rod Main Bearings
- Solenoid Relay (2-Stroke)
- Solenoid Relay (4-Stroke)
- Spark Plugs (2-Stroke)
- Spark Plugs (4-Stroke)
- Stators
- Thermostat Kits
- Water Pump Parts (2-Stroke)
- Water Pump Parts (4-Stroke)
- Mercruiser
- Engine Parts
- View All »
- Alternators
- Camshafts, Bearings, Lifters & Push Rods
- Carburetors
- Connecting Rod Bearings
- Crankshaft Bearings
- Distributor Assembly & Components
- Distributor Gears
- ECMs, Coils, Wires & Spark Plugs
- Engine Couplers
- Engine Gaskets
- Exhaust Manifolds & Elbows
- Flame Arrestors
- Fuel Coolers
- Fuel Injection Components
- Fuel Pumps & Filters
- Ignition Tune-up Kits
- Intake & Exhaust Valves
- Oil Coolers
- Oil Pumps & Components
- Piston Rings
- Pistons
- Rocker Arms & Hardware
- Starter Parts
- Starters & Solenoids
- Thermostats, Housings & Covers
- Timing Chains & Gears
- Valve Caps, Springs & Keepers
- V-Belts & Serpentine Belts
- Water Hoses—Engine Supply
- Water Hoses—Exhaust Cooling
- View All »
- Transom & Drive Parts
- View All »
- Bearing Carriers
- Bellows
- Drive Shaft Housing & Sterndrive Units
- Drive Shaft Housing Bearings
- Drive Shaft Housing Gears
- Gear Case Bearings
- Gear Case Gears
- Gear Case Seals
- Gear Case Shafts
- Gear Case Shims
- Gimbal Bearings
- Installation Gaskets
- Trim Cylinders
- Trim Cylinder Hardware
- Trim Cylinder Hoses
- Universal Joints (U-Joints)
- Water Pump Impellers & Kits
- View All »
- Engine Parts
- Page Numbers
INSTRUMENTS
WATER PRESSURE KIT
ANALOG WATER PRESSURE FITTING KIT
Components needed for water pressure gauges
Fitting kit to install analog gauge to engine.
150 4 Stroke Engines
150 HP 4 Stroke
ANALOG WATER PRESSURE FITTING KIT
WATER TEMPERATURE SENDERS
Water temperature senders used for operation of a temperature gauge.
WATER TEMPERATURE SENDER
Fitting kit to install analog gauge to engine.
150 HP 4 Stroke
WATER PRESSURE PICK-UP KITS
A two wire temperature sender for use on V‑6 outboard product. Furnished
HOSE KIT
standard on engine powerhead, the fiche card specific to the application should be
used to verify correct use.
WATER TEMPERATURE SENDER
Contains the necessary tubing, tee fitting and instruction sheet to allow the use of a
15 PSI Analog Water Pressure Gauge with the otherwise digital 1.5L OptiMax
outboard.
A four wire temperature sender for use on V‑6 outboard product. Furnished
Fits the 75/90/115hp (1.5L) OptiMax Outboard Engine, Model Year 2004 and
newer.
standard on engine powerhead, the fiche card specific to the application should be
used to verify correct use.
238